Efficiency of Electrocoagulation for Laboratory Wastewater Treatment Using Aluminum Electrodes

• Angga Ardiyasa Sudrajat

  Department of Chemistry, Faculty of Sciences and Informatics, Universitas Jenderal Achmad Yani, Jl. Terusan Jenderal Sudirman, Cimahi, Indonesia.

  Author

• Anceu Murniati

  Department of Chemistry, Faculty of Sciences and Informatics, Universitas Jenderal Achmad Yani, Jl. Terusan Jenderal Sudirman, Cimahi, Indonesia.

  Author

• Arie Hardian

  Material and Environmental Development Center, Universitas Jenderal Achmad Yani, Jl. Terusan Jenderal Sudirman, Cimahi, Indonesia.

  Author

Environmental analysis of waste generated from residual samples in a testing laboratory is necessary to mitigate its impact. This study aims to assess the performance of electrocoagulation (EC) using aluminum (Al) electrodes in reducing Chemical Oxygen Demand (COD), Total Suspended Solid (TSS), and pH level in laboratory wastewater. This investigation successfully employed an EC process utilizing Al electrodes in both anode and cathode configurations. The experimental conditions include Voltage (10, and 20 V), contact time (15, 30, 45, and 60 minutes), and the electrode configuration (monopolar and bipolar). The results indicated that a bipolar configuration of Al electrode relatively outperformed a monopolar configuration. Optimal condition was achieved at 20 V, and contact time of 60 minutes. Results showed COD removal efficiency up to 96.15% reducing COD from 627.45 to 24.183 mg/L, TSS removal efficiency up to 92.45%, lowering TSS from 53 to 4 mg/L. While pH increased during the process, it remained within acceptable limits. This substantial reduction in pollutants significantly improved water quality, surpassing regulatory standards. The results suggest that EC is a promising approach for achieving sustainable treatment for laboratory wastewater.

• PDF

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.